Charnwood W650 Operations Instructions Page 1

10” CAST IRON SAWBENCH WITH SLIDING CARRIAGEOPERATING INSTRUCTIONSMODEL: W650Charnwood, Cedar Court, Walker Road, Bardon Hill, Leicestershire,LE67 1TU

Using a set square (fig24) adjust the back stop for the angle fence with a flat bladedscrewdriver (fig25) so that the angle fence is at 90 degrees to

Fit blade guard (fig27) and extraction pipe support using the fasteners supplied (fig28)then connect the extraction pipe (fig29)Fig.27 Fig.28Fig.29

MalfunctionsMachine vibratesClamping levers for height and diagonal adjustment are not locked.Sawing tool is not tightly screwed.Cuts are not clean/wo

IntroductionTo get the most out of your new table saw, please read through this manual and safetyinstructions before use. Please also save the instruc

Safety RulesAs with all machines, there is a certain amount of hazard involved with the use of this circular saw-bench. Use the machine with the respe

Large stock. Do not attempt to saw long or wide boards unsupported where spring or weight couldcause the board to shift position.Job completion. If th

While workingWood must be hand fed uniformly and without jerking into the sawing tool, slightly more slowly whenprocessing hard wood or work pieces, w

ASSEMBLY INSTRUCTIONSTools Required.10mm Spanner.13mm Spanner.4mm Hex Key.5mm Hex Key.6mm Hex Key.8mm Hex Key.Straight Edge.Set Square.Phillips Screwd

AssemblyFit the rise and fall handle (part no 58) (fig 5) and the blade tilt handle (part no 58) (fig 6)using the 5mm hex key supplied. Fit the side e

Loosen the four M6 bolts using a 10mm spanner (fig10) then slide aluminium extrusioninto place (fig 11 and 12) then re-tighten the M6 bolts.Remove one

Loosely attach the leader pole (part no 35) to the machine (fig 16) then slide the rip fenceonto the leader pole (fig 17)Clamp the rip fence onto the