Charnwood LA 45 Operations Instructions download pdf (Page 13)

THERMOSTAT

ASSEMBLY

PRE LIGHTING CHECK

Before lighting the fire check the cold setting distance of the

thermostat.

With the control knob at the maximum setting the flap should

be 18 mm from the air inlet as shown in Fig. 11. To adjust the

distance slacken the locking nut and adjust as necessary. When

set correctly re-tighten the locking nut. Ensure that the flap

opens and closes freely as the knob is turned.

Fit the side panels, hood and top grid onto the appliance.

Instructions for this are enclosed with the panel pack.

Replace any internal parts previously removed.

Before initial lighting check the following points:

1. The bottom grate bars must all be fitted and should move

freely and easily when the riddling mechanism is operated.

2. The plates round the sides and back of the grate must be in

position and sitting correctly.

3. The throat plate must be fitted in the roof of the appliance.

COMMISSIONING

FREESTANDING KIT

On completion of the installation and after allowing a suitable

period of time for the fire cement and mortar to dry out, the

fire should be lit and checked to ensure that smoke and fumes

are taken from the appliance up the chimney and emitted

safely. Also check all joints and seals.

The central heating pump should be adjusted to give the

correct water flow against the circuit resistance and the

system should be correctly balanced.

On completion of the installation and commissioning please

leave the operating instructions with the customer and advise

on the use of the fire and any controls on the system.

A freestanding kit is available. Details of dimensions and

outputs are available on request.

INSTALLATION INSTRUCTIONS

Thermostat Flap

Locking Nut

18mm

Fig. 11 Thermostat Setting

charnwood

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Charnwood LA 45 Operations Instructions Page 13