In non-smoke control areas other fuels may also be burnt. For
instructions on burning other fuels please ask your supplier
for the ‘‘Charnwood Multifuel Instruction Supplement’’.
At first you may find it helpful to try several fuels to find the
most suitable. If you are unable to obtain the fuel you want
ask your supplier, an approved fuel distributor, or the Solid
Fuel Association (tel. 0800 600 000) to suggest an
alternative.
Use the spanner type tool to open and close the doors. Turn
the knob on the right hand door anti-clockwise to open and
clockwise to close. When closing the doors do not push on
the enamel with the tool as this can chip the enamel, instead
push the doors on the door knobs.
Place some paper and dry kindling wood or fire lighters on
the grate and cover with a small amount of fuel. Turn the
thermostat control knob to the maximum setting and light the
paper or fire lighters. Close the doors and allow the fire to
burn until the fuel is well ignited then load with more fuel and
adjust the thermostat to the required level.
On initial lighting, the appliance may smoke and give off an
odour as the silicon paint with which the firebox is painted
reacts to the heat. This is normal and will cease after a short
time. In the meantime the room should be kept well
ventilated.
Before relighting the fire, riddle, remove any clinker from the
firebed and empty the ashpan.
The rate of burning and hence the output is controlled by the
control knob on the left hand side of the appliance, shown in
Fig. 1. This is linked to a thermostat which controls the boiler
PETROLEUM COKE IS NOT SUITABLE FOR USE ON
THIS APPLIANCE, ITS USE WILL INVALIDATE THE
GUARANTEE
DOOR OPERATION
LIGHTING
CONTROLLING THE FIRE
GENERAL POINTS
FUELS
Before lighting the fire check with the installer that the work
and checks described in the installation instructions have been
carried out correctly and that the chimney has been swept, is
sound, and free from any obstructions.
WARNING There must not be an extractor fan fitted in the
same room as this appliance as this can cause the appliance to
emit smoke and fumes into the room.
If the appliance is fitted in place of an open fire then the
chimney should be swept one month after installation to clear
any soot falls which may have occurred due to the difference
in combustion between the appliance and the open fire.
When using the fire in situations where children or infirm
people are present please use a fire guard to prevent
accidents. The fire guard should be manufactured in
accordance with BS 6539.
This appliance has been designed to conform with BS.3378. It
has obtained the approval of HETAS Ltd. (formerly DSFAAS
Ltd.) for burning the following smokeless fuels.
HETAS Ltd. approval only covers the use of the following
smokeless fuels on this appliance:
Ancit,
Anthracite Large Nuts,
Centurion,
Cosycoke,
Extracite,
Maxibrite,
Phurnacite,
Sunbrite Doubles,
Welsh Dry Steam Coal (Large Nuts).
HETAS Ltd. approval does not cover the use of other fuels
either alone or mixed with the above fuels, nor does it cover
instructions for the use of other fuels.
The above fuels are all suitable for use in smoke control areas.
3
®
charnwood
OPERATING INSTRUCTIONS
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals