®
OPERATING INSTRUCTIONS
6
OPERATING INSTRUCTIONS
MULTIFUEL GRATE
Your Charnwood stove is fitted with a multifuel grate which enables
both solid fuels and wood to be burned effectively. The grate has
two positions:
1) In the solid fuel position the grate bars are vertical with gaps in
between allowing primary combustion air to come up through the
grate and through the fuel bed.
2) In the wood position the grate bars are horizontal. In this position
ash is able to build up on the grate as is necessary for effective wood
or peat burning.
When the fire is burning normally the air control gives enough
airwash to keep the glass clean. However, it will not always be
possible to keep the glass clean with the air control fully closed.
Movement of the grate from one position to the other is effected
using the riddler handle, as shown in Fig. 3. To put the grate into the
solid fuel position, pull the handle out fully.
To riddle the appliance, pull the riddler handle rapidly in and out
several times. When burning wood or peat, the ash should be
allowed to build up and riddling should only be carried out once or
twice a week, using the glove provided if necessary.
The rate of burning and hence the output is controlled by the air
control (see Fig. 2).
Open the air control fully (boost position) when lighting or when
rapid burning is required. It should not be left fully open for long
periods as this can cause over-firing or excessive smoke production.
For a higher burning rate move the air control to the ‘nominal
output’ position or for low burning to the fully closed position.
CONTROLLING THE FIRE
Pull handle in and out to riddle
Fig. 3 Riddling and setting the grate: C Four Insert
Low
Output
Nominal
Output
Boost
Fig. 2 Air control
BEFORE LIGHTING
For best results when burning smokeless fuel the u
needs removing. To remove the
start by removing the fuel retainer, this will need to be lifted
out at an angle to avoid knocking the stove. Once the fuel retainer
has been cleared, lift out the left and right grate plates which will
allow access to grate assembly. Carefully remove the grate assembly
by lifting the grate support bars from underneath. Lift out the rear
grate support to reveal the .
ndergrate
blanking plate undergrate blanking
plate
undergrate blanking plate Applying
equal pressure to both sides, push up the undergrate blanking plate
from the hooks on the undergrate air inlet and remove and keep for
future use.
Reassemble by following the above steps ensuring that the middle
grate bar is located in the riddler slide as shown below.
Push up
Fuel Retainer
RH Grate plate
LH Grate plate
Grate Assembly
Rear Grate Support
Middle Grate bar
in riddler slide
Undergrate
Blanking Plate
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals